The 2262/2272 Quad M4 Unlocked Receiver Board is a classic 4-channel wireless remote control module designed for simple, reliable switching of multiple devices from a single remote. Based on the industry-standard PT2272 decoding chip and compatible with PT2262 encoding remotes, this module provides four independent relay outputs that can be controlled wirelessly with minimal setup.
The “M4” designation refers to the momentary (jog) operating mode of the decoder. In this mode, the relay for each channel closes only while the corresponding button on the remote is held down, and opens when the button is released. This behavior is ideal for applications requiring continuous activation, such as motor jogging, doorbell buttons, or any scenario where the output should only be active during the button press.
The “Unlocked” designation means the board ships without a fixed pairing code. Instead, it uses solderable address pins on both the transmitter and receiver that must be matched to establish communication. This provides flexibility for custom coding schemes and multi-device setups, though it requires a one-time hardware configuration step during installation.
The receiver board features four independent relay outputs, each capable of switching loads up to 10A at 250VAC or 30VDC. This makes it suitable for controlling lamps, small motors, fans, solenoid valves, and other household or industrial devices. Each channel has a corresponding LED indicator that lights up when the relay is activated, providing clear visual feedback of the current state.
The module operates at 315MHz or 433MHz (depending on the version selected) and uses ASK/OOK modulation for signal transmission. The superheterodyne or super-regenerative receiving circuit provides reliable reception with good anti-interference characteristics in typical indoor environments. Effective remote distance is approximately 20–50 meters in open areas, depending on the specific transmitter and environmental conditions.
The board is compatible with a wide range of PT2262/PT2272 encoding remotes and clone chips, including EV1527 and other fixed-code variants. This makes it easy to integrate into existing remote control systems or replace lost or damaged remotes.
Whether you are building a home automation system, a remote-controlled robot, a wireless lighting setup, or an industrial control panel, the 2262/2272 Quad M4 Unlocked Receiver Board provides a proven, cost-effective foundation. It is suitable for individual makers, students, and businesses purchasing in bulk for education, prototyping, or product development.
Features
-
4 independent relay outputs — Control up to four devices separately from a single remote.
-
Momentary (jog) mode operation — Each relay is active only while the corresponding remote button is held, ideal for motor jogging and doorbell applications.
-
10A relay capacity — Each channel handles up to 250VAC / 30VDC at 10A, sufficient for most household and industrial loads.
-
Unlocked address design — Solderable address pins on transmitter and receiver allow custom coding for multi-device setups.
-
PT2262/PT2272 compatible — Works with standard encoding/decoding chipsets and common fixed-code remotes.
-
LED status indicators — Each channel has an LED that lights up when the relay is activated.
-
Wide frequency options — Available in 315MHz and 433MHz versions to suit different regional requirements.
-
Reliable reception — Superheterodyne or super-regenerative architecture for stable performance in typical indoor environments.
Technical Specifications
| # | Parameter | Specification |
|---|---|---|
| 1 | Decoder Chip | PT2272 (M4 mode) |
| 2 | Encoding Compatibility | PT2262 / EV1527 / fixed-code remotes |
| 3 | Channels | 4 independent relay outputs |
| 4 | Relay Rated Load | 10A 250VAC / 10A 30VDC per channel |
| 5 | Operating Frequency | 315MHz or 433MHz (version dependent) |
| 6 | Modulation | ASK / OOK |
| 7 | Operating Voltage | DC 5V (receiver board) |
| 8 | Remote Distance | Approx. 20–50 meters in open area |
